Flight at high altitude

From NPrize
Revision as of 02:08, 19 December 2011 by Vincent (talk | contribs) (more on air density)
Jump to navigationJump to search

Flight at high altitude

Some information is summarized in the main page already, in the aircraft section.

Gas properties and altitude

Density is used to calculate lift of an wing and thrust of an engine amongst other. We need to know what air densities will be faced in order to design everything.

Air density depends on pressure. This table gives atmospheric pressure and temperature depending on altitude. We can see that a tenth of ground atmospheric pressure is met at around 16km altitude, and a hundredth of it at around 31km altitude.

Air density in the atmosphere is also related to the ratio of air vapour in it, as indicated on this page. The page also contains lots of formulas and calculators, most importantly the air density calculator that we'll use right below. Water vapour however, is much more rare when temperature goes down, as it does in the higher troposphere or low to mid stratosphere that we're aiming. The calculator gives us, with temperature and pressure values taken from the table mentioned above, values for density of:

  • 1.214 kg/m^3 at sea level
  • 0.1877 kg/m^3 at 15km altitude
  • 0.0441 kg/m^3 at 25km altitude
  • 0.017 kg/m^3 at 30km altitude

Approaches overview

High engine power at low air density

Is it possible to have a low total pressure ratio engine operating at subsonic inlet speeds and low air density? The MiG 25 has supersonic inlet, which allows him to have a significant pressure increase before the compressor actually gives energy to the flow. A subsonic input air flow in the high-altitude conditions is likely to not provide enough oxygen for the combustion to maintain by itself, or a too poor mass flow rate to the turbine.

High lift at low air density

High engine power in low air density generally means supersonic flight, or at least, high flight speeds, which in return increase the lift of the aircraft or decrease its wingspan. Our next step is to make some calculations of the required winged area for subsonic low-density air travel, and assess the feasibility of our air launch to orbit project.